Addonics UDFH15 Guide de l'utilisateur Page 7
- Page / 8
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: 408-453-6212 Email: www.addonics.com/support/query/
6.8. Calc. Checksum
Calculates a checksum value for the Copy Area function defined in the
Setup Menu.
NOTE: This function is not to be used to validate copies. Media that have
identical content and structure may still have different checksums. Testing
media devices for accurate duplication should only be done using the
Compare function.
Setup Menu
7.1. Startup Menu
Defines the function that will appear by default after power-on testing is
completed. Any of the Main Menu functions may be selected.
Default is 1. Copy.
7.2. Copy Area
Determines the method for copying from the source device to the target
devices: “Whole Media” copies the entire device, sector-by-sector – without
any regard to the contents. “System and Files” copies only the contents of
file systems understood by the firmware: FAT16, FAT32, NTFS, ext2 or ext3.
File systems not recognized by the firmware will be copied using the “Whole
Media” method.
Default is “System and Files.”
7.3. Button Beep
Enables or disables the unit sounding a “beep” noise when buttons are
pressed.
7.4. Asyn Hold Time
During operations that use Asynchronous Mode, this setting determines the
delay after all media have been removed before confirming that an operation
is complete. Once that delay has been expired, the operation will halt and
the display will request confirmation to exit the function. Press OK to confirm
the exit, ESC to resume the function.
Settings are “Turn OFF” to disable this feature, meaning Asynchronous
functions will continue indefinitely until ESC is pressed, or a selection of
delay in seconds or minutes.
Default is “Turn OFF.”
7.5. Target Tolerance
Used to define the acceptable difference in capacity during the copy func-
tion, using one of three settings:
No Limit: Target capacity will not be considered before proceeding.
100% Same: Target capacity will be considered suitable only if the capacity
is identical to the source.
Allow tolerance: Selecting this option offers two additional choices: Set UP
Limit allows either “No Limit” or a percentage greater than the source
capacity. Set LOW Limit allows either “No Limit” or a percentage less than
the source capacity.
The Target Tolerance menu item displays the current setting in parentheses.
Default is “No Limit.”
NOTE: The size of the file system on the source is always duplicated with all
contents. Target devices greater than or less than the source capacity will
not reflect any changes to correct the difference.
Produits connexes et manuels pour Duplicateurs de médias Addonics UDFH15
(8 pages)Bosch HGI8054UC Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Herde Bosch HGI8054UC.
Wir stellen 2 PDF-Handbücher Bosch HGI8054UC zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Spezifikationsblatt, Anleitung zur Fehlerbehebung
Commentaires sur ces manuels